How to Replace Rotted Rafter Ends on a Gable Roof - how to work with manufacturers to develop skin
English

 A manufacturing enterprise professed in the reaearch & development design,and manufacturing of cosmetics ODM.

How to Replace Rotted Rafter Ends on a Gable Roof - how to work with manufacturers to develop skin care products

by:NOX BELLCOW     2019-11-18
How to Replace Rotted Rafter Ends on a Gable Roof  -  how to work with manufacturers to develop skin care products
When replacing the ditch or fascia plate, you may find extensive decay at the end of some ditch.
The rotten rafter end not only lets you not have anything to pin on when you re-hang the fascia plate and the ditch, but also endangers the stability of the roof.
Replacing the rotten rafter end on the gable roof is a problem with removing the existing end and installing new wood.
While this is a simple process, it is necessary to ensure a reliable repair.
Place the ladder or extended ladder under the end of the rafter with the greatest damage.
If you are using an extension ladder, please let your assistant hold the bottom of the ladder when you measure and repair the rafter tail.
Measure the area from the end of the after tail to the good wood with a tape measure.
When measuring, stick the tape measure out a few inches of wood.
This helps ensure a strong fit on the replacement end. Cut 2-by-6-
Measure the inch plate with a circular saw.
Calculate the number of rafter ends that need to be replaced and cut the same number of plates to the same length.
Mark the first rafter end in the original measurement.
Use the Speed Square to draw a line at the mark to ensure a straight line.
Use the recombine saw to cut the end of the rafter on the line, be careful not to pass through the roof sheath.
Cut between the top edge of the rafter end and the bottom of the roof sheath with a reciprocating saw.
This will pass through the nail that holds the sheath to the end of the rafter.
Pull the old rafter end off the roof eaves.
Keep the replacement at the end of the remaining rafter.
Make two lines on the side of the replacement rafter end and the rafter end, 1 inch from the top and bottom edges.
This is where your stake is inserted into the wood.
Drill at the end of the rafter near the mark, 1/2 in diameter-inch drill bit.
Drill holes in the matching end of the replacement rafter end in the same way.
At least 4 inch deep per hole. Cut the 1/2-
6-inch diameter stakeinch pieces.
Squeeze out a few drops of gum in the holes on each piece of wood.
Use a hammer to knock the wooden pin into the hole at the end of the rafter.
Apply the wood glue to the end of the rafter and the top edge of the replacement end.
Place the replacement end on the exposed PIN and tap the pin end until the other end is flush with the pin.
Repeat for the remaining rafter ends that need to be replaced.
Custom message
Chat Online 编辑模式下无法使用
Leave Your Message inputting...