spray paint that will not melt foam products | ehow - foam skin care products
When using foam, special attention must be paid to the use of products that do not damage the foam.
Many products used in ordinary applications, such as glue and paint, will work on many seemingly delicate materials, but even the most dense foam will be swallowed up.
Paint and glue for special recipes use materials that are harmless to foam.
Learn what to look for when using foam.
A solvent is a liquid that can dissolve another substance.
Solvent is used in paint and glue to make sure they remain stationary after applying.
Common solvents include acetone (an ingredient in nail polish remover) and methyl acetate (found in glue and paint ).
All paints contain solvents, and many of them contain solvents that dissolve the foam.
When the air is used to expand materials such as polystyrene, plastic, etc. , foam is produced.
Expanded polybenzene foam (commonly referred to as foam plastic) is used to make decorations, disposable cups and plates, packaging materials and other items.
Due to the open structure of the foam, otherwise the solvent that does not dissolve the regular polystyrene will dissolve the expanded foam by penetrating the air bag and contacting with more polystyrene surface area.
Therefore, avoid the use of paint containing toluene, PX and acetone components. Foam-
Safe painting well-
Known solvents not included in the above list: water. Water-
The base paint is attached to the surface of the foam without dissolving the foam. To find foam-
Safe paint, looking for "water-
Based on the "or" H2O "at the front of the tank.
Krylon produces a product that replaces ordinary paint, called Krylon H2O latex paint, and many other brands offer similar products.
If you're not sure if the paint is foam-
Safe, spray a small amount on a piece of waste foam to check if there is a negative impact.
If the paint is harmful, it will start to dissolve the foam in a few minutes.
When the only paint available contains harmful solvents, the surface of the foam can be protected from damage by applying the foam
Safety seal before painting.
Apply two layers of polyacrylic acid, water-
Protective finish based on sealed foam.
You will then have a surface suitable for painting with any paint.
If there is no other option, if used separately in a series of very thin coatings, paint with solvent may work, and these coatings do not go deep into the foam.